Learn how to replace an intake manifold and intake manifold gaskets in your car or truck. I am upgrading my intake manifold from a non PI intake to a PI performance intake which will hopefully add some Horsepower and Torque! I also show you how to install a water pump, and how to tap the intake port for a coolant temperature sensor.

Performance Intake: https://amzn.to/2L5klQD
Extendable Ratchet: https://amzn.to/2xiKUje
Torque Wrench: https://amzn.to/2IRnTsW
3/8's Tap and 37/64" Drill Bit set: https://amzn.to/2LBHV8s
Center Punch: https://amzn.to/2GXMPcl
Heater Tube and Fitting: https://ebay.to/2GYFuJt
Intake Manifold Gasket: https://ebay.to/2skKQJP
No Spill Coolant Funnel: https://amzn.to/2Jch6cF


→ Become a ChrisFix Subscriber: http://www.youtube.com/subscri....ption_center?add_use
→ Instagram: https://www.instagram.com/chrisfixit
→ Facebook: https://www.facebook.com/chrisfix8
→ Website: http://www.ChrisFixed.com
→ My Channel Home Page: https://www.youtube.com/ChrisFix

**If the video was helpful, remember to give it a "thumbs up" and consider subscribing. New videos every Week**

Disclaimer:
Due to factors beyond the control of ChrisFix, I cannot guarantee against improper use or unauthorized modifications of this information. ChrisFix assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. Use this information at your own risk. ChrisFix recommends safe practices when working on vehicles and or with tools seen or implied in this video. Due to factors beyond the control of ChrisFix, no information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. Any injury, damage, or loss that may result from improper use of these tools, equipment, or from the information contained in this video is the sole responsibility of the user and not ChrisFix.